Porsche Recliner Bracket Installation
Fits 991.1/991.2 GT3, GT3RS & 981/718 GT4 Model Seats
Required Tools & Hardware
| Tools Required | Included Hardware |
|---|---|
| • 6mm Allen Wrench • 8mm Allen Wrench • 15mm Wrench • 16mm Wrench |
• 2x M10 x 25mm Bolts • 2x M10 Flange Nuts • 2x Washers • 2x M6 x 25mm Flange Bolts |
Disclaimer: Professional installation recommended. We are not responsible for damage or injury caused by improper installation.
Installation Steps
Step 1: Raise the Seat
Raise the seat to its highest position using the power/manual adjustment controls to gain clearance under the seat frame.
Step 2: Remove Factory Hardware
Using an 8mm Allen key and a 16mm wrench, unbolt the factory shoulder screw and nut. Push the screw out of the bracket. Save this hardware as you will reuse it in Step 4.
Step 3: Insert Recliner Brackets
Tilt the seat back slightly and position the recliner bracket in place. Insert the included M10 screw and M10 flange nut into the lower hole. Hand-tighten using a 6mm Allen and 15mm wrench.
Step 4: Secure Upper Seat Mount & Tighten
Align the top hole of the bracket with the OEM seat mount, reinsert the factory shoulder screw, and thread the OEM nut back on. Verify alignment on both sides, then torque all bolts firmly.